Por favor, use este identificador para citar o enlazar este ítem: https://hdl.handle.net/11000/30653

Multilayered additive-manufactured half-wavelength coupled line filters


no-thumbnailVer/Abrir:

 4. 2020_AEUE_Q2.pdf



1,97 MB
Adobe PDF
Compartir:

Este recurso está restringido

Título :
Multilayered additive-manufactured half-wavelength coupled line filters
Autor :
García Martínez, Héctor  
Ávila Navarro, Ernesto  
Torregrosa-Penalva, Germán  
Bronchalo, Enrique  
Blanco Angulo, Carolina
Bozzi, Maurizio  
Editor :
Elsevier / Elsevier Masson
Departamento:
Departamentos de la UMH::Ingeniería de Comunicaciones
Fecha de publicación:
2020-06-17
URI :
https://hdl.handle.net/11000/30653
Resumen :
This work presents the design, fabrication and measurements of third-order multilayered filters by additive manufacturing technology. The filters are fabricated using conventional half-wavelength line resonators and a low-cost 3d polylactic acid polymer additive manufacturing process, which allows rapid prototyping and fabrication of complex topologies. The designs, performed at a centre frequency of 2.0 GHz, aim to provide fast manufacturing and get enhanced performances when compared to conventional coupled line third order filters using microstrip technology on commercial substrates. The simulated and measured responses of the fabricated prototypes are in all cases in good agreement.
Palabras clave/Materias:
additive manufacturing
coupling coefficient
multilayered filter
3D printing
Área de conocimiento :
CDU: Ciencias aplicadas: Ingeniería. Tecnología
Tipo documento :
application/pdf
Derechos de acceso:
info:eu-repo/semantics/closedAccess
Attribution-NonCommercial-NoDerivatives 4.0 Internacional
DOI :
https://doi.org/10.1016/j.aeue.2020.153320
Aparece en las colecciones:
Artículos Ingeniería Comunicaciones



Creative Commons La licencia se describe como: Atribución-NonComercial-NoDerivada 4.0 Internacional.