Publication: Low-Cost Direct-Writing of Silver-Based Ink for Planar Microwave Circuits up to 10 GHz
Loading...
Author
Blanco Angulo, Carolina
Arias, Julia
Rodríguez-Martínez, Alberto
Vicente Samper, Jose Maria
Sabater-Navarro, Jose Maria
Journal Title
Journal ISSN
Volume Title
Date
Citation
IEEE Acces, VOLUME 11, 2023
Conference
Publisher
Institute of Electrical and Electronics Engineers
Abstract
Direct ink writing (DIW) of conductive ink is a printed electronics technology that allows
a variety of electronic circuits to be produced in a simple way and with minimal waste of materials.
In recent years it has been used for rapid prototyping of RF circuits typically working at S-band frequencies
(2–4 GHz). In an attempt to extend this frequency range while maintaining cost-effective prototyping, this
work has focused on proving the feasibility of DIW of silver-conductive (SC) ink for the fabrication of
planar microwave circuits beyond 10 GHz, more specifically, ultra-wideband (UWB) antennas for medical
applications. For this purpose, the DC and RF performance of the SC ink, as well as the FR4 substrate
used, were first evaluated. Based on the comparison between experimental and simulated results, we have
found that the effective RF conductivity of the SC ink is approximately 27.6% of its DC value and 3.4% of
the copper conductivity. A few test microstrip circuits were fabricated by DIW, namely two S-band filters
and one UWB antenna. The overall measured performance of all of them agreed well with simulations.
In particular, the DIW antenna exhibited a bandwidth of 8.2 GHz (between 2.4 and 10.6 GHz), and was
compared with an identical copper antenna showing that both have very similar characteristics. It was also
found that the lower conductivity of SC ink as compared to copper led to a gain reduction of only 0.3 dB.
